Blacksmith Anvil Parts and its uses

Blacksmith Anvil is a large and heavy-weight metallic block used for metalworking. These Anvils are made up of special graded cast iron. Anvil tools are used for making tools or project that falls in the category of metalworking like chains, knives, blades, and many more.

There are different parts of anvil used for different purposes:

1. The face of the anvil

2. The horn of the anvil

3. The Table of the anvil

4. The Hardie Hole

5. The Pritchel Hole

Each of these anvil tool parts plays an important role, which we have described in the following section:

1. Face of Anvil: The face of the anvil is the primary surface where most of the work is done, which is located on the top of its structure. It is used to shape different metals by striking with the hammer. It resists most of the load and pressure when the hammer is striking on it. It is usually made up of high-quality material because it has to handle high pressure.

2. The horn of the Anvil: For bending the rods, the horn of the anvil is used. This part is placed near the face of the anvil. It is a cone-shaped part used for spherical or round-shaped tasks. Horn is parallel to the face, which is separated by the step.

3. The Table of the Anvil: This is an area which is located between face and horn. The table of the anvil is also called Step. Its height is slightly higher than the horn and lower than the face. This part is used to cut the different objects on its edge.

4. The Hardie Hole: It is a square hole located inside the face surface on the end opposite of the horn, and it is also known as the heel. These tools are used for several purposes such as bending, punching etc.

5. The Pritchel Hole: It is a round-shaped hole that is an intuitive tool to use when punching rounded holes into a workpiece.

 

Ajay Tools Manufacturers blacksmith anvil tools by using high-quality material. These tools are exported worldwide in different countries like the USA, Russia, South America, South Africa & Europe etc. If you have any requirements for anvil tools, then you can contact us at +91 9463518295.